Grip Puppies - Big Paw
GRIP PUPPY BIG PAW OVERSIZED GRIP COVERS FOR HARLEY DAVIDSON & HONDA GOLDWING FITS 5" X 1.45-1.66"
* Reduce Vibration
* Increase Comfort
* Improve Throttle Control *
Each Grip is hand finished to provide enhanced grip/texture.
The ends of the grips are hand radiused for a neat, comfortable rounded finish!
A soft, squeezable grip that simply slips over your standard rubber grip (no need to remove standard grip) and leaves you with a soft, squeezable, tactile grip that will give greater comfort to any bike as well as reducing vibration through the grip. A significant benefit is greater throttle control by nature of a larger grip diamiter (especially on fly by wire throttles!)
Rock solid when fitted, a simple and very effective solution:-)
( NOTE *** Be wary of inferior grips that are just slices of insulation foam tube! These are the wrong type of material, don't have the textured high grip surface and won't have the comfortable radiused ends!)
Grip covers slip over your existing grips. Made of a special high tech material that is U.V. , ozone and oxidation resistant. Foam will not weaken or crack as a result of years of outdoor exposure. Wall thickness is approximately .15 inches (0.38cm).
Grip Puppies will fit OVER all standard grip sizes.
The standard Grip Puppy will fit standard bars sizes and grips. They are 5" (12.7cm) long and will fit grips that are 1.45(3.68cm) to 1.65 (4.19cm) inches in diameter. (remember these fit OVER your standard grips, you don't need to remove them)
Grip Puppies can be trimmed to length with a craft knife or similar if needed (using appropriate care!)
These are great for adding a little extra thickness and comfort to your grips.
Easy installation, just add a bit of soapy water to help slide them on, once the water dries up, you're ready to go!
Will also work with heated grips.