 |
pair, 1" rise & 1" pullback
Part #LEH.00.039.152
Our Price $117.99
Silver or Black
Provides a more upright, comfortable riding position by raising and retracting the original 7/8" (22mm) diameter tubular handlebar. No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and install the replacement top clamp using included hardware. Barbacks increase handlebar height by 25mm (1.0") and move them back 25mm (1.0"), producing an overall handlebar displacement of 35.4mm (1.4") at a 45 degree angle from the original position.
This product has replaced LEH.00.039.132 and LEH.00.039.133 and offers a superior powdercoated finish while fitting a wider range of bikes.
When installed, there may be a slight gap between the bar riser and the top clamp. This gap allows the top clamps to be torque-tightened onto the bar riser to prevent the bar from spinning.
No change of control cables, wiring, or hoses is required for most motorcycle models for normal 20mm to 30mm handlebar risers, HOWEVER:
Barbacks offer significant additional displacement of the handlebars and are more likely to require modification of cable/wiring/hose slack after installation than are standard handlebar risers.
The installer should always check for adequate cable/wiring/hose slack after installing any handlebar riser!
Simply put, the amount of cable slack varies on factory bikes even within a single model and year due to slight differences in the way the lines/cables are routed through the bike. While 99.9% of all bikes will not need adjustment of cables to install handlebar risers, you should ALWAYS check for adequate slack after installation.
| Please follow all Torque Specifications to the letter Failure to do this will void warranty.
Confirmed fit list: Aprilia BMW Ducati Honda Kawasaki KTM MZ Suzuki Triumph* Yamaha
These handlebar risers will only fit standard handlebar mounts that are symmetrical and perpendicular to each other; as such, these handlebar risers will not fit the BMW F650GS, Kawasaki Z1000, Kawasaki Z750S, or any other motorcycle with asymmetrical handlebar mounts. This riser will not fit bikes with oversize (1" or 28mm diameter) handlebars, such as the KTM LC8 Adventure 950. If your handlebar mounts don't look similar to those pictured on this page, please contact us before ordering to confirm that the item will fit your bike. While installation of these barbacks is possible on many bikes, such installation sometimes requires rerouting or extending the original hoses or cables.
LEH.00.039.113 barbacks have outside top dimensions of 52mm L x 20mm W. Hole spacing in the base is 25mm (inside-to-inside diameter) and 45mm (outside-to-outside diameter). LEH.00.039.123 top clamps have outside dimensions of 52mm L x 20mm W x 21mm H. Hole spacing in the top clamp is 25mm (inside-to-inside diameter) and 45mm (outside-to-outside diameter). Kit includes: |
| Copyright © 2010 DualSport Plus. All rights reserved. | Web Design & Hosting by Adventure Motorrad Marketing |